Arjo Enterprise E8000X, Service Manual

Page: 76 / 105

Servicing Instructions Enterprise E8000X Service Manual
Page 72
25 Roller Buffer - Replacement
This section describes how to replace the roller buffer. Reference is made throughout this section to
Figure 23 on page 68.
25.1 Removal
To remove the roller buffer:
25.1.1 Lift up the roller buffer moulding (Fig 23, Item 3). Undo the M5 Nyloc nut (Fig 23, Item 6) and
withdraw the M5 hex head bolt (Fig 23, Item 5) from the mounting tube.
25.1.2 Collect the shakeproof washer (Fig 23, Item 4) and remove the roller buffer moulding.
25.1.3 If necessary, pull the corner tube liner (Fig 23, Item 2) up and out of the tube.
25.2 Installation
To install the roller buffer:
25.2.1 If previously removed, fit the corner tube liner (Fig 23, Item 2) down into the mounting tube on
the bed extension fabrication (Fig 23, Item 1). Make sure the transverse holes in the tube and
liner are aligned.
25.2.2 Fit the roller buffer moulding (Fig 23, Item 3) over the tube.
25.2.3 Fit the shakeproof washer (Fig 23, Item 4) onto the M5 hex head bolt (Fig 23, Item 5). Fit the
bolt through the holes in the tube and liner.
25.2.4 Secure the assembly with a new M5 Nyloc nut (Fig 23, Item 6).
This procedure describes the replacement of the foot end roller buffer and/or
corner tube liner; use the same method to replace those at the head end.