96
WC169A
6. Install the lower front through-bolt and the rear lower
cap screw securing the rear drive gear case; then with
new lock nuts, tighten the through-bolts to 38 ft-lb,
and the cap screw to 20 ft-lb.
WC170A
7. Secure the front driveshaft to the front drive output
flange using new “patch-lock” cap screws and tighten
to 40 ft-lb; then connect the starter cable.
WC187A
8. Crimp the clamp onto the rear drive coupler boot.
WC172B
9. Connect the speed sensor (D), stator connector (E),
and the CKP sensor (F); then install the gear shift
cable onto the shift arm (C) and secure with the E-clip
(A) and jam nut (B).
WC177A
WC362A
10. Making sure the tab on the throttle body aligns and
fully engages the alignment slot on the intake boot,
install the throttle body and tighten the clamp nut to
30 in.-lb; then install the engine ground cable.
