148
GC057A
2. Place the ring gear with selected shim into the cover
and measure the ring gear to thrust button clearance
with a thickness gauge. Clearance should be 0.002-
0.004 in.
GC058A
3. If clearance is as specified, remove the ring gear and
thrust button; then place a drop of red Loctite #271 on
the threads and tighten to 8 ft-lb (left-hand threads).
4. If clearance is not as specified, repeat steps 1 and 2
using thicker (clearance too great) or thinner (clear-
ance too small) until correct specification is reached.
REAR DRIVE INPUT SHAFT/
HOUSING
Removing/Disassembling
1. Remove the cap screws securing the rear drive input
shaft/housing to the rear gear case; then remove the
input housing assembly.
GZ183
2. Remove the clutch pack from the clutch basket; then
remove the snap ring securing the clutch basket (A) to
the input shaft (B) and remove the clutch basket.
GZ392
GZ176A
GZ177
3. Remove the input shaft from the input housing; then
remove the oil seal.
GZ180
