71
3. Remove the cap screw (left-hand threads) securing the
drive clutch assembly; then using an appropriate
clutch puller, remove the drive clutch.
WC666A
4. Remove the drive belt.
5. Remove the fixed driven sheave.
6. Remove and discard the cap screws securing the V-
belt housing to the crankcase; then remove the V-belt
housing. Account for two alignment pins.
WC664A
7. Remove the cap screws securing the clutch cover;
then using a rubber mallet, carefully remove the cover.
Account for two alignment pins.
WC662A
NOTE: Only the clutch cover bearing and seal are
servicable. If any other component of the cover is
damaged, the cover must be replaced.
8. Remove and retain the two machine screws and bear-
ing retainers.
GZ500A
9. Using a suitable press, remove the seal and bearing
simultaneously from the clutch cover.
GZ527
Servicing Right-Side
Components
DRIVE CLUTCH
Disassembling
NOTE: Note the timing marks (X) on the cover, spider,
and movable sheave. These must be aligned when
assembling the drive clutch for balance purposes.
1. Loosen the machine screws securing the cover.
Remove every other cap screw from the cover; then
while firmly holding the cover, remove the three
remaining screws equally.
WC659
