130
4. Using a seal removal tool, remove the input shaft seal.
Account for a spacer.
GC010
5. Remove the snap ring securing the input shaft bearing;
then place the pinion housing in a press and remove
the bearing.
GC011
AF984
KX219
Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the exist-
ing snap ring making sure the sharp edge of the snap
ring faces to the outside.
GC012
GC011
2. Install the input shaft seal making sure it is fully
seated in the edge of the housing.
GC014
3. Lubricate the input shaft with High-Performance #2
Molybdenum Disulphide Grease packing the boot ribs
and splines; then assemble allowing excess grease to
freely escape. Slight pressure on the boot will be pres-
ent during assembly. Secure with new clamps.
NOTE: Any time drive splines are separated, clean
all splines with parts-cleaning solvent and dry with
compressed air; then lubricate with recommended
grease.
4. Install the input shaft into the pinion housing; then
secure in the bearing with a circlip.
