129
WC267A
10. Remove the front drive actuator from the differential;
then remove the front boot clamp from the front drive
coupler and slide the boot off.
WC275A
11. From under the vehicle (Wildcat/X) or inside the vehi-
cle (Wildcat 4/4X), slide the driveshaft to the rear suf-
ficiently to allow differential to move to the rear 6-8
inches.
12. Remove the upper and lower through-bolts; then slide
the differential rearward and lay it on the right side.
Remove from the vehicle from either left or right side.
WC 277
Disassembling Input Shaft
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
GC004A
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring. Note
the location of all the components for assembling pur-
poses.
GC015
CD106
3. Remove the snap rings from the input shaft; then
remove the input shaft from the pinion housing.
GC009A
