127
GC002A
3. While holding the actuator firmly forward, tighten the
front cap screw to hold the actuator in place; then
install but do not tighten the two remaining cap
screws.
GC001
4. Loosen the front cap screw; then tighten the cap screw
on the driveshaft side.
AG926
NOTE: It is important to tighten this cap screw while
the others are loose to ensure proper seating of the
actuator.
5. Tighten the remaining cap screws; then connect the
electrical plug to the main harness.
6. Turn the ignition switch to the ON position and check
the operation by shifting the drive select switch sev-
eral times.
7. Secure the wiring harness to the frame with a nylon
cable tie; then install the inner fender panel.
Front Differential
REMOVING
1. Remove the forward belly panel (Wildcat/X) or seats
and center console (Wildcat 4/4X); then drain the
lubricant from the differential.
2. Using an appropriate jack or lift, raise the vehicle so
the wheels are off the floor and support with jack-
stands under the lower A-arms.
WC081D
3. Remove the front wheels and account for the hub
plates; then remove the hub nuts and Belleville wash-
ers.
WC240B
WC304
4. Remove the left and right brake calipers; then remove
the hub/brake disc assemblies.
