183
WC303A
7. Install the brake caliper and secure with new “patch-
lock” cap screws tightened to 20 ft-lb.
8. Install the hub plate making sure it fits completely
over the nut and lies flat against the hub.
WC317A
NOTE: If the hub plate cannot be fully installed due
to misalignment of the hub nut, tighten the nut until
properly aligned and plate is fully installed.
9. Install the wheel; then using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a final
torque factor of 80 ft-lb. Install the hub cap.
10. Remove the support stands and lower to the floor.
Wheels and Tires
TIRE SIZE
The Wildcat is equipped with low-pressure tubeless tires of the
size and type listed in General Information. Do not under any
circumstances substitute tires of a different type or size.
WC774A
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be as specified in
the General Information section.
REMOVING
1. Secure the vehicle on a support stand to elevate the
wheels; then remove the hub cap.
2. Remove the nuts securing the wheels; then remove the
wheels.
NOTE: On Limited models, the bead lock must be
removed before attempting to remove the tire from
the rim.
CLEANING AND INSPECTING
1. Clean the wheels and hubs with parts-cleaning solvent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and leaks.
INSTALLING
NOTE: On Limited models if a new tire is being
installed, install the bead lock and tighten the exist-
ing screws to 11 ft-lb.
1. Install the wheel.
2. Using a crisscross pattern, tighten the wheel nuts in 20
ft-lb increments to a final torque factor of 80 ft-lb.
Install the hub cap.
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air pressure in
each tire. Adjust the air pressure as necessary to meet the
recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.
NOTE: If repair is needed, follow the instructions found
on the tire repair kit or replace the tire.
! WARNING
Use only Arctic Cat approved tires when replacing tires.
Failure to do so could result in unstable vehicle operation.
! WARNING
Always use the size and type of tires specified. Always
maintain proper tire inflation pressure.
CAUTION
Do not mix tire tread patterns. Use the same pattern type
on front and rear. Failure to heed warning could cause
poor handling qualities of the vehicle and could cause
excessive drive train damage not covered by warranty.
! WARNING
Do not operate the vehicle if tire damage exists.
