137
CD110
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a rear
gear case.
1. Remove the seal using a seal removal tool.
CC899
NOTE: Prior to installing the seal, apply High-Per-
formance #2 Molybdenum Disulphide grease to the
seal outside diameter.
2. Using Gear Case Seal Installer Tool, evenly press the
seal into the cover bore until properly seated.
CF278
3. Repeat steps 1-2 for the opposite side.
INSTALLING
1. Lay the differential assembly on its right side and
place in the frame of the vehicle; then turn it upright
and maneuver into the mounting brackets.
WC277
2. Apply molybdenum grease to the splines and install
the forward driveshaft into the differential splined
coupler; then install the three Allen-head bolts in the
driveshaft coupler and tighten to 40 ft-lb.
WC267A
3. Install the two through-bolts and secure the differen-
tial with new lock nuts. Tighten to 38 ft-lb.
WC276A
4. On the Wildcat/X, secure the carrier bearing to the
carrier bearing support bracket with two bolts and
nuts. Tighten the nuts to 38 ft-lb.
CAUTION
Make sure the tool is free of nicks or sharp edges or
damage to the seal may occur.
