86
PR147
4. Install the cap screws securing the drive couplers to the
drive flanges and tighten to 40 ft-lb.
PR120A
5. Set the exhaust pipe in place; then install the muffler
and align the assembly to the engine. Install two cap
screws securing the exhaust pipe to the cylinder head
and tighten to 20 ft-lb.
6. Install the inlet boot on the V-belt housing; then
install the exhaust duct connecting the outlet housing
to the V-belt housing. Tighten all clamps securely.
HDX140A
PR144B
7. Connect the lower coolant hose to the water pump
housing; then connect the upper coolant hose to the
thermostat housing. Tighten the hose clamps
securely.
8. Install the starter wire on the starter and tighten the
nut securely; then connect the alternator connector
and gear position switch connector (XT).
PR838
PR266C
9. From the right-side, connect the speed sensor con-
nector, fuel level sensor connector, and temperature
sensor lead; then install the spark plug cap.