80
2. Mount a dial indicator and base on the surface plate.
Position the indicator contact at point 1 of the crankshaft.
H1-003
3. Zero the indicator and rotate the crankshaft slowly.
4. Maximum runout must not exceed specifications.
NOTE: Proceed to check runout on the other end of the
crankshaft by positioning the indicator contact at point 2
and following steps 3-4.
Measuring Crankshaft
(Web-to-Web)
1. Using a calipers, measure the distance from the outside
edge of one web to the outside edge of the other web.
H1-005
2. Acceptable width range must not exceed specifications.
COUNTERSHAFT
GZ281A
Disassembling
1. Remove the shift forks noting the positions for assem-
bling; then remove the high driven gear outer washer,
high driven gear, high driven gear bearing, high driven
gear bushing, and high driven gear inner washer.
GZ283A
2. Remove the drive gear; then remove the snap ring secur-
ing the reverse driven gear dog and bushing to the coun-
tershaft.
GZ296
GZ312
3. Remove the reverse driven gear dog.
CAUTION
Care should be taken to support the connecting rod
when rotating the crankshaft.
CAUTION
When disassembling the countershaft, care must be
taken to note the direction each major component (dog,
gear) faces. If a major component is installed facing the
wrong direction, transmission damage may occur
and/or the transmission will malfunction. In either case,
complete disassembly and assembly will be required.