Arctic Cat 650 Twin2004, Service Manual

Page: 137 / 210

6-9
6
AF994
2. Install the input shaft seal making sure it is flush
with the edge of the housing.
KX221
KX222
3. Install the input shaft into the housing; then secure
it in the bearing with the circlip.
KX210
4. Place the input shaft assembly with a new gasket
onto the gear housing; then secure with the
existing cap screws. Tighten to 2.9-3.5 kg-m
(21-25 ft-lb).

NOTE: If a new gear housing is being installed,
tighten the cap screws to 3.5-4.3 kg-m (25-31 ft-lb).
KX209
KX158
Disassembling Pinion Gear

NOTE: This procedure can be performed on a
rear gear case.
1. Using a T-40 torx wrench, remove the cap screws
securing the input assembly. Account for the
coupler, fork, and spring.
KX209
2. Using a T-40 torx wrench, remove the cap screws
securing the differential cover. Account for and
make note of the ID tag location for assembling
purposes.