Arctic Cat 650 Twin2004, Service Manual

Page: 183 / 210

8-17
8
INSPECTING

NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect wiring harness, three-prong connector,
lens, base, cap screws, and socket for damage.
2. Inspect all wires for corroding, pinching, and
cracking.
Seat
REMOVING/INSTALLING
3. Inspect the bulb for wattage, voltage, and proper
operation.
INSTALLING
1. Place the assembly into position on the frame and
secure with torx-head cap screws and any washers.
2. Tighten the cap screws securely.
3. Route the wiring harness over the rear frame; then
connect the three-prong connector.
0739-289
1. To remove the seat, pull the seat lock lever
backward (located under the rear rack between the
storage compartment and the frame). Raise the
rear of the seat and slide it rearward.
2. To lock the seat into positon, slide the front of the
seat into the seat retainers and push down firmly
on the rear of seat. The seat should automatically
lock into position.
KEY
1. Seat Assy
2. Cover
3. Foam
4. Base Assy
5. Base Bumper
6. Base Bumper
7. Staple
8. Plate
9. Rivet
10. Spring
11. Seat Latch