Arctic Cat 650 Twin2004, Service Manual

Page: 119 / 210

5-18
4. Install the timing inspection plug.
If ignition timing is incorrect, replace the CDI and
pick-up coil.
Electronic
Speedometer/Indicator
Lights
REMOVING
1. Remove the four nylon fasteners securing the
instrument pod; then remove the ignition switch
retaining nut.
2. Remove the front rack and front fenders; then dis-
connect the multi-pin connector.
3. Remove the three nuts securing the mounting
studs; then remove the speedometer.
TESTING
ATV2208A
1. Connect a 12-volt battery with the positive wire to
terminal (1) and the negative wire to terminal (16);
then connect a jumper wire from terminal (1) to
terminal (5). All LCD displays on the speedometer
should appear for one second.

NOTE: If any functions (segments or displays)
are not normal or display as indicated, the speed-
ometer must be replaced.
ATV2208B
2. Connect the positive wire to terminals (1) and (5)
and the negative wire to terminal (16); then
depress and hold the mode button (A). The display
(B) should cycle through the four modes
CDO-ODO-TRIPA-TRIPB-HOUR.
ATV2121
3. Cycle the speedometer to TRIPA or TRIPB mode;
then check that when the SET/RESET button (A)
is depressed, the display shows 0.0 (B).
ATV2122
4. Check that when the TIME SET (A) and the
SET/RESET (B) buttons are depressed, the time
(C) will reset.