Arctic Cat 650 Twin2004, Service Manual

Page: 135 / 210

6-7
6
AF902D

NOTE: To remove the panels, there will be a
torx-head screw and three cable ties per side.
16. Using a T-30 torx wrench, remove the three screws
securing the front drive actuator to the gear case;
then remove the actuator (see Front Drive
Actuator in this section).
AG925
17. Remove the lower differential mounting bolt.
Account for a lock nut and washers.
CD026
18. Remove the upper differential mounting bolt.
Account for a lock nut and washers.
CD016
19. Free the differential assembly from the frame
mountings; then shift the assembly forward in the
frame sufficiently to disengage the splines of the
driveshaft from the engine.
KX161
20. Lay the differential on right side; then maneuver it
out of the frame with the driveshaft attached.
KX159
Disassembling Input Shaft Housing

NOTE: This procedure can be performed on a
rear gear case.
1. Using a T-40 torx wrench, remove the cap screws
securing the input shaft housing cover.
2. Using a rubber mallet, remove the cover. Account
for a gasket. Remove the fork, collar, and spring.
Note the location of all the components for
assembling purposes.