Arctic Cat 650 Twin2004, Service Manual

Page: 136 / 210

6-8
CD106
3. Remove the circlip; then remove the input shaft
from the housing.

NOTE: The input shaft-to-bearing clearance is a
hand-press fit. A light tap with a rubber mallet may
be necessary to remove the shaft from the bearing.
4. Remove the input shaft from the housing.
KX210
5. Using a seal removal tool, remove the input shaft
seal.
KX218
6. Remove the snap ring securing the input shaft
bearing; then place the input shaft housing in a
press and remove the bearing.
KX219
AF984
Assembling Input Shaft Housing
1. Place the input shaft housing in a press and install
the input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of
the snap ring faces to the outside.
KX220
! CAUTION
Care must be taken to press on the outside race
only or bearing damage will occur.