3-60
C. Cylinders
D. Pistons
NOTE: Steps 1-10 in the preceding sub-section
must precede this procedure.
11. Remove the cap screws securing the water hose
union to the cylinder; then remove the union from
the cylinder. Account for an O-ring.
GZ140A
12. Remove the two nuts securing the cylinder to the
crankcase.
GZ141A
GZ160A
13. Lift the cylinder off the crankcase taking care not to
allow the piston to drop against the crankcase.
Account for the gasket and two alignment pins.
GZ142
GZ144
14. Using an awl, remove one piston-pin circlip.
GZ145
15. Using the Piston Pin Puller, remove the piston pin.
Account for the opposite-side circlip. Remove the
piston.
NOTE: It is advisable to remove the opposite-side
circlip prior to using the puller.
NOTE: Support the connecting rod with rubber
bands or a piece of hose to avoid damaging the rod
or install a suitable connecting rod holder.
AT THIS POINT
To service cylinder, see Servicing Top-Side Compo-
nents sub-section.
CAUTION
When removing the cylinder, be sure to support the pis-
ton to prevent damage to the crankcase and piston.
Summary of Contents for 2013 Prowler XT
