22
9. Rotate the handlebar to the full-left position; then lift
and slide the panel to the rear and lift the rear up to
clear the handlebar.
CD765A
NOTE: It may be necessary to rotate the body panel
to the right to align the opening with the handlebar.
CLEANING AND INSPECTING
1. Clean all fender components with warm soap and
water.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Rotate the handlebar to the full-left position; then
place the front body panel over the handlebar and
rotate and lower into position.
CD765
2. Connect the headlight connectors to the appropriate
headlights and the front accessory plug wires to the
accessory plug.
CD681
3. Make sure the rubber grommets and bushings are in
place; then place the front rack into position and
secure with the cap screws and lock nuts. Tighten
securely.
4. Install the footwells and foot rests. Tighten securely.
5. Install the cap screws securing the front body panel
to the frame and rear panel.
FI470A
6. Install the shift lever spring, shift lever, and pivot
axle; then tighten the axle nut securely.
CD779
7. Install the instrument pod and ignition switch; then
secure with two reinstallable rivets and the ignition
switch retaining ring.
8. Set the storage compartment box into position; then
install the storage compartment cover making sure
the mounting tabs engage the slots. Slide rearward to
secure and lock by engaging the lid lock.
