65
FI596A
10. Install the water pump drive gear and secure with the
nut. Tighten to 28 ft-lb.
FI547
11. Install two alignment pins and a gasket on the mag-
neto cover; then install the water pump housing
assembly. Tighten the cap screws to 8 ft-lb.
FI541A
FI539
12. Install the water pump cover with a new O-ring and
secure with the four cap screws. Tighten to 8 ft-lb.
FI538
13. Connect the coolant hoses to the water pump and
secure with the hose clamps. Tighten securely.
Right-Side Components
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pedal axle.
Account for a flat washer.
AT THIS POINT
To service center crankcase components only, proceed
to Removing Right-Side Components.
AT THIS POINT
To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
