15
English
7
CONNECTING THE CABLE TO THE CONTROL UNIT AND SERVICES
• Use only the cables provided with the ARAG computers.
• Take care not to break, pull, tear or cut the cables.
• Use of unsuitable cables or cables not provided by ARAG automatically voids the
warranty.
• ARAG is not liable for damage to the equipment, persons or animals caused by
failure to observe the above instructions.
7.1
Connecting the multi-pin connector
• Bravo 30X:
Connect the multi-pin connector to the panel and connect the other end of its cable
to the control unit.
• Bravo 32X:
install the multi-pole connector running from the control unit to the control panel.
Make sure that it is correctly fi tted and turn the collar clockwise until it locks in place.
7.2
Connecting the valves
• All valve connectors must be equipped with gaskets before installation (Fig. 9).
• Make sure the gaskets are correctly fi tted to avoid infi ltration of water when opera-
ting the control unit.
Fit the connectors to the valves following the markings given in the general system installation
diagram in your possession (par. 5.1 - System confi guration).
Fig. 9
• Remove the protector cap (1, Fig. 9) from the electrical valve.
• Fit the gasket (2) onto the connector (3) and push the connector fully on (4):
take care not to
bend the valve’s electrical contacts.
• Tighten screw (5) fully down.
If the number of control panel switches is different from the number of section val-
ves, connect the cables as shown in Table 12.
N. SECTIONS
SWITCHES
CABLES
2
2 - 4
2 - 4
3
2 - 3 - 4
2 - 3 - 4
4
1 - 2 - 4 - 5
1 - 2 - 4 - 5
6
1 - 2 - 3 - 4 - 5 - 6
1 - 2 - 3 - 4 - 5 - 6
Tab. 12