Aqua Phase
, A Division Mid-State Stainless Inc. ●
330
W.
Benson Ave. ●
PO Box 228 ●
Grantsburg, WI 54840 ●
USA
800-208-9274 ●
715-463-5851
●
FAX: 715-463-5853
● Email: [email protected] ●
WEB: www.aqua-phase.com
Possible Causes/Solutions:
1.
ARE YOU USING AQUA PHASE DETERGENT & RINSE SOLUTIONS?
•
Aqua Phase chemicals are specifically designed for use in the Aqua Phase
systems.
They are formulated to clean equipment virtually spot-free and speed
drying time.
You may order cleaning chemicals by calling your dealer or the
factory.
DETERGENT SOLUTION CONTAINER IS EMPTY.
•
Check the level of detergent and refill if necessary.
The chemical solutions are located inside the Chemical Cabinet.
FILTER SCREEN(S) NOT CLEAN.
•
Clean Primary Filter Screen (Primary Filter Screen is located in the bottom of the
Water Reservoir located inside the Wash Chamber).
SPRAY NOZZLES CLOGGED
•
Virtually inspect spray nozzles for debris.
•
For spray nozzles that are clogged, note the position of the spray nozzle’s relative
spray angles.
CHEMICAL PUMP HOSES ARE WORN.
LONGER WASH CYCLE REQUIRED.
•
Set the wash cycle time to
“7 MINUTES”
or to the longest time cycle available.
•
Press the “Start” button, and allow Aqua Phase to run a complete cycle.
WATER TEMPERATURE TOO LOW.
•
Check the temperature of the water reaching the Aqua Phase.
•
Drain the Aqua Phase.
•
Press the
“START”
button. Allow the Aqua Phase to fill.
•
As soon as Aqua Phase begins to pump, press the
“STOP”
button.
•
Open the front door, place a thermometer in the water reservoir to check the water
temperature. The recommended water temperature is 115-140°. (105° is
functional).
ITEMS NOT CLEANED
PROPERL
Y
Summary of Contents for AQ-F250
Page 2: ......