Aqua Phase AQ-F250, Operating Manual, Page: 12 / 89

Warning:
Wear Protective Clothing When Working With Any Chemicals.
Warning:
Consult the material safety data sheets located in the
back of this manual and your company’s
hazardous substance policy before handling any chemicals.
Key to Aqua Phase chemical solution hoses:
•
The RED hose is for detergent.
•
The BLUE hose is for rinse-aid.
•
The CLEAR hose is for disinfectant, if installed.
NOTE: The disinfection injection rate is preset at the factory for use of a disinfectant that requires a
dilution rate of 1 oz. per gallon of water. Contact the factory if adjustment of the injection rate is
necessary.
3. On the control panel at the front of the machine:

Set the " WASH TIME " switch to " 3 MIN ".

Set the “ RUN/DRAIN ” switch to “ RUN ”.

Set the wash mode switch to " CLEAN & DISINFECT " or " CLEAN ONLY " if no disinfectant
application system is installed.
4. Close the front door.
5. Press the “ START ” button. The “ START ” button is located on the control panel at the front of the
machine.
•
Allow Aqua Phase to run a two complete cycles before washing any items.
If Aqua Phase does not start, see the "TROUBLESHOOTING: Will not start ” section of this manual or
call the factory for support.
BASIC SET-UP PROCEDURES
(continued)
1. Place Chem i cal Solutions in the Chemical Tray (located inside the Chemical Cabinet at the rear of the
Aqua Phase) as the locations marked
"DETERGENT"
and
"RINSE-AID".
2. Remove chem i cal bottle caps and place the appropriate colored hoses in bottle openings RED hose for
Detergent/ BLUE hose for Rinse-Aid.
• Do not dilute the Detergent or Rinse-Aid solutions.
Aqua Phase, A Division of Mid-State Stainless, Inc.  330 W. Benson Ave.  PO Box 228  Grantsburg, WI 54840  USA
800-208-9274  715-463-5851  FAX: 715-463-5853  Email: aquaphase@medwashers.com  Web: www.aqua-phase.com