Aqua Phase AQ-F250, Operating Manual, Page: 18 / 89

DISINFECTANT APPLICATION
SYSTEM (option)
Follow all instructions provided by the manufacturer of the disinfectant solution that you
choose to use including dwell time, application, removal, and proper handling of the
disinfectant.
The Disinfectant Application System allows you to automatically apply a disinfectant solution.
The disinfectant solution used with the Aq ua Phase Disinfectant Application System and the
proper use of that disinfectant solution is responsible for the level of disinfection results that
achieved.
Disinfectant Solution:
•
The Disinfectant Application System is preset at the factory to apply disinfectant at the rate
of 1 ounce per gallon of water.
•
Aqua Phase uses 100 to 110 ounces of water per disinfectant cycle.
• Aqua Phase
can p rovide disinfectant solution products specifically formulated to work with
the
Aqua Phase System.
Order your solutions by calling your dealer or
Aqua Phase
at
1-800- 208-9274.
OPERATING INSTRUCTIONS
• Be sure that you are using a 1-ounce per gallon disinfectant. If not, see the note below.
•
Place a one (1) gallon container of your disinfectant solution in the Chemical Tray
(located inside the C hemical C abinet at the rear of the Aq ua Phase ).
o
Insert the
CLEAR
hose into the disinfectant container.
o
Close the Chemical Cabinet door.
• At the front of the Aqua Phase, select the desired WASH MODE : Clean Only, Clean and
Disinfect, or Disinfect Only.
Note:
If you choose to use a disinfectant that calls for a different dilution rate, Aqua Phase can be
modified to accommodate that rate. For information on how to make this modification, please
call the factory for assistance or review the Disinfectant Mixing Valve “Dema” technical
information included in this manual.
Aqua Phase, A Division of Mid-State Stainless, Inc.

330 W. Benson Ave.

PO Box 228

Grantsburg, WI 54840

USA
800-208-9274  715-463-5851  FAX: 715-463-5853  Email: aquaphase@medwashers.com  Web: www.aqua-phase.com