Aqua Phase
, A Division Mid-State Stainless Inc. ●
330
W.
Benson Ave. ●
PO Box 228 ●
Grantsburg, WI 54840 ●
USA
800-208-9274 ●
715-463-5851
●
FAX: 715-463-5853
● Email: [email protected] ●
WEB: www.aqua-phase.com
•
Check the temperature of the water reaching the Aqua Phase.
•
Drain the Aqua Phase.
•
Press the
“START”
button. Allow the Aqua Phase to fill.
•
As soon as Aqua Phase begins to pump, press the
“STOP”
button.
•
Open the front door, place a thermometer in the Water Reservoir to check
the
water
temperature. Water temperature should be between 105°-130°.
•
AQ-260 Rinse-Aid Solution requires a water temperature at or above 105°
THE WATER SUPPLY TO THE AQUA PHASE IS “HARD” WATER.
•
The AQ-240 Cleaning Solution, in conjunction with the spray nozzles are
in
effect
cleaning
the water and taking the hard water particles out of
suspension.
•
A Water Fill Assembly (5-10 Micron Cartridge) from Aqua Phase factory,
installed at
the
Fill Line may correct this
de
pending
on
the water contaminants.
•
It may be correctable, pending the pH of the water, and the totally
dissolved
solids of the
water to alter the injection rate of the AQ-240 Cleaning Solution to reduce the amount of
solids being taken out of suspension.
RINSE-AID SOLUTION CONTAINER EMPTY
•
Check the level of rinse-aid solution, refill if necessary. The chemical
solutions are
located
inside the Mechanical Cabinet at the rear of the Aqua
Phase.
127(6
•
The solution injection rates are preset at the factory for the worst possible water condition
expected to be found.
•
If spotting or clouding is present only on the first item washed, it is possible that you will
need to run a “warm-up cycle” with Aqua Phase. Run a “3-minute” wash cycle with the
Wash Chamber empty to allow the Wash Chamber to be warmed-up prior to
commencing
normal washing operations.
•
If problem persists, call the factory for assistance.
Possible Causes/Solutions:
W
ATER TEMPERATURE BELOW 105°F:
•
Inspect chemical hoses for cracks and inspect chemical hose fittings for cracks or if loose.
•
Replace if damaged—you may order replacement parts by calling your dealer or Aqua
Phase.
4
RINSE CHEMICAL INJECTOR HOSE OR FITTINGS ARE WORN.
ITEMS
W
ASHED HA
V
E
W
ATER SPOTS OR
CLOUDY FILM
Summary of Contents for AQ-F250
Page 2: ......