Aqua Phase AQ-F250, Operating Manual, Page: 13 / 89

9
FILL & DRAIN LINES
HOSES
•
The Aqua Phase Washer System has female, garden hose style connectors.
•
One hose is for filling the washer (Fill Line) and is connected to your water supply .
•
One hose is for draining the washer (Drain Line).
FILL LINE CONNECTION
• The Aqua Phase System is designed with a built-in Fill Line Air-Gap.
•
See “Fill Line Options” diagram page for Water Supply options/methods.
DRAIN LINE CONNECTION
•
The Aqua Phase System should be drained according to local plumbing codes.
o
THE END OF THE DRAIN HOSE MUST BE HIGHER THAN THE DRAIN
CONNECTION TO AQUA PHASE SYSTEM.
o
If the Drain Hose is run directly to a floor drain, water will siphon out of the Aqua
Phase during operation.
• Typically, the Drain Hose will run to a stand pipe or utility sink (similar to a home washing
machine set-up). Use of standpipe is recommended. See “Drain Line Options” diagram
page. Please check with your local building codes for stand-pipe requirements. A standpipe
should be a minimum of 2” diameter with a minimum height of 32”.
•
The drain hose must be secured at the drain to prevent a whipping action.
A SET OF (2) 10’ LONG HOT-WATER RATED HOSES ARE INCLUDED WITH
THE AQUA PHASE WASHER SYSTEM.
If needed, 25’ hot-water rated hoses are available from Aqua Phase at additional cost.
PLEASE CALL AQUA PHASE TECHNICAL SERVICE AT 1-800-208-9274 WITH ANY QUESTIONS
Aqua Phase, A Division of Mid-State Stainless, Inc.  330 W. Benson Ave.  PO Box 228  Grantsburg, WI 54840  USA
800-208-9274  715-463-5851  FAX: 715-463-5853  Email: aquaphase@medwashers.com  Web: www.aqua-phase.com