Setup
Document No. D113-015
Page 17 of 77
Revision 1.9
window opened. The device configuration window can be reopened by either double clicking
the module in the Project Explorer tree or right-clicking the module and selecting
Configuration
.
Figure 3.14. – HART 4In module configuration
Refer to the additional information section in this document for Slate’s installation and
operation documentation.
3.4.
HART 4 PARAMETERS
The HART 4 module parameters are configured using the Slate configuration utility. The
configuration form is divided into multiple tabs to configure the general, DNP3 and channel
specific parameters.
When downloading this configuration into the module it will be saved in non-volatile memory
that persists when the module is powered down.
NOTE:
When a firmware upgrade is performed the module will clear all HART
4 configuration.
The general configuration consists of the following parameters:
Parameter
Description
Instance Name
This parameter is a user defined name to identify between various HART 4 modules.
