Installation
Document No. D113-015
Page 6 of 77
Revision 1.9
2.
INSTALLATION
2.1.
MODULE LAYOUT
The module has six ports at the bottom of the enclosure as shown in the figure below. The
ports are used for Ethernet, the four analog HART channels and power. The power port uses
a three-way connector which is used for the DC power supply and the earth connection.
The Ethernet cable must be wired according to industry standards which can be found in the
additional information section of this document.
Figure 2.1. – HART-4 (Input) module side view
The module provides six diagnostic LEDs as shown in the front view figure below. These LEDs
are used to provide information regarding the module system operation, the Ethernet
interface, and the status of each of the four analog HART channels.
