![background image](http://html.mh-extra.com/html/amx/udm-rx02n/udm-rx02n_operation-reference-manual_2938757039.webp)
UDM-0808-SIG WebConsole
29
UDM-0808-SIG, UDM-RX02N and UDM-ABB-8-SIG Operation /Reference Guide
Once you have successfully logged into the Configuration Manager, the IP Settings page is displayed, and can
be edited as needed.
IP Settings
Select IP Settings from the Admin drop-down menu to open the IP Settings page (FIG. 22). Use the options
on the page to specify network/IP settings for this UDM-0808-SIG.
FIG. 22
IP Settings page
DHCP:
Click to toggle DHCP on this unit (default = enabled).
Note that DHCP must be enabled in order for the zero-configuration client (i.e.
Bonjour for Windows) to detect the UDM-0808-SIG on the network.
See the
Bonjour (Zero-Configuration) Client
section on page 23 for details.
Hostname:
Enter a Hostname for this unit (enabled only if DHCP is disabled).
IP Address:
Enter an IP Address for this unit (enabled only if DHCP is disabled).
Subnet Mask:
Enter a Subnet Mask for this unit (enabled only if DHCP is disabled).
Gateway:
Enter a Gateway for this unit (enabled only if DHCP is disabled).
Domain Suffix:
Enter the Domain Suffix for this unit.
DNS 1, 2, 3:
Enter up to three DNS addresses for this unit.
Accept:
Click to save changes. Note that IP Settings changes require a reboot (see
below).
Cancel:
Click to exit this page without saving any changes.
Reboot:
Click to initiate a system reboot. IP Settings changes only take effect after a
reboot.