UDM-0808-SIG Wiring and Connections
6
UDM-0808-SIG, UDM-RX02N and UDM-ABB-8-SIG Operation /Reference Guide
UDM-0808-SIG Rear Panel Components
FIG. 6 shows the components on the rear panel of the UDM-0808-SIG:
Connecting UDM-RX02N Receivers to the UDM-0808-SIG
1.
Connect a standard Cat 5/5e/6/7cable to a UDM OUTPUT port (1-8) on the UDM-0808-SIG.
2.
Connect the other end of the Cat 5/5e/6/7 cable to the “UDM Hub” port on the UDM-RX02N Receiver.
3.
When the power is switched on 2 LEDs will be visible at the Hub port – Amber (phantom power enabled)
and Green (UDM receiver connected to Hub port).
UDM Output Ports (RJ45)
The eight RJ45 ports on the rear panel of the UDM-0808 (see "UDM Output Ports 1-8" in FIG. 6 above)
provide connectivity to a UDM-RX02 Multi-Format Receiver.
UDM Port Pinouts
The following table provides detailed pinout information for the UDM port:
An incorrectly terminated cable will result in the following scenarios:
FIG. 6
UDM-0808-SIG - Rear Panel Components
A/V Transmission Over UTP (UDM)
RJ45
Pin #
568A
Termination
A/V Signals
568B
Termination
Color
Pair #
RGB
YPbPr
CVBS
S-Video
Color
Pair #
1
3
Red +
Y +
CVBS S1 +
Y +
2
2
3
Red -
Y -
CVBS S1 -
Y -
2
3
2
Blue +
Pr +
CVBS S3 +
C +
3
4
1
Green +
Pb +
CVBS S2 +
1
5
1
Green -
Pb -
CVBS S2 -
1
6
2
Blue -
Pr -
CVBS S3 -
C -
3
7
4
Audio, Data, Power +
Audio, Data, Power +
Audio, Data, Power +
Audio, Data, Power +
4
8
4
Audio, Data, Power -
Audio, Data, Power -
Audio, Data, Power -
Audio, Data, Power -
4
Incorrectly Terminated Cable Results
RJ45
Pin #
RGBHV Video
Component Video
Composite Video
SVideo
UDM Audio & Data RX
Green LED
1-2
No RED
No Y
No Video 1
No Y
On With Audio & Data RX
3-6
No BLUE
No Pr
No Video 2
No C
On With Audio & Data RX
4-5
No GREEN
No Pb
No Video 3
NONE
On With Audio & Data RX
7-8
NONE
NONE
NONE
NONE
Always OFF
ETHERNET port (RJ45)
Serial port (RJ12)
UDM OUTPUT Ports 1-8 (RJ45)
Input connections
Power connector/switch
Cascade In/Out
Input connections
