AMX Modero G5, Instruction Manual

Page: 114 / 144

Programming - Send Commands
104 Modero G5 Touch Panels - Configuration and Programming
^RAF and ^RMF Embedded Codes / Escape Sequences
^RAF and ^RMF Embedded Codes
Parameter Embedded Code Code Description
protocol %P <0-1> Set protocol: either HTTP (0) or FTP (1).
Note: FTP is not yet supported.
user %U <user> Set Username for authentication.
password '%S <password> Set Password for authentication.
host' %H <host> Set Host Name (fully qualified DNS or IP address).
path %A <path> Set directory path. The path must be a valid HTTP URL minus the
protocol, host, and filename. The only exception to this is the inclusion of
special escape sequences and in the case of the FTP protocol, regular
expressions.
file %F <file> The file or program that will return the resource. The file must be a valid
HTTP URL minus the protocol, host, and path. The only exception to this
is the inclusion of special escape sequences and in the case of the FTP
protocol, regular expressions.
refresh %R <refresh 1-65535> The number of seconds between refreshes in which the resource is
downloaded again. Refreshing a resource causes the button displaying
that resource to refresh also. The default value is 0, which means to only
download the resource once for each time it comes into view (or if
preserve is set, only once period).
Note: For Motion JPEGs, the Refresh interval should always be 0.
preserve %V <0-1> Set the value of the preserve flag. A value of 0 (the default) means the
resource should be reloaded each time it comes into view. A value of 1
means the resource should be preserved in cache after the first time it is
loaded, and not reloaded each time it comes into view. This value is
ignored if the Refresh interval is greater than 0.
dynamo %D Enable/disable Fast Dynamo. Panel will attempt to accelerate this
resource in hardware.
Note: Fast Dynamo is not yet supported.
Notification setting %C<on,off,once> Indicates whether a notification is required when a Dynamic Image is
loaded/refreshed. The string following the %C can be:
1. on - notifications are sent whenever the named dynamic image
resource is loaded/refreshed.
2. off - notifications are not sent (default).
3. once - notifications are sent one time whenever the named dynamic
image resource is loaded/refreshed.
^RAF and ^RMF Escape Sequences
Sequence Panel Information Sequence Panel Information
$DV Device Number $AP Address port
$SY System Number $CC Channel code
$IP IP Address $CP Channel port
$HN Host Name $LC Level code
$MC Mac Address $LP Level port
$PX X resolution of current panel mode/file $BX X Resolution of Current button
$PY Y resolution of current panel mode/file $BY Y Resolution of Current button
$ST Current state $BN Name of Button
$AC Address code