5
5800 SE 78th St. Ocala, FL 34472
Modular HURRiCHiLL Installation & Operations Manual
P: (800) 327-3015
Pre-installation Checks
• Check components against the packing list. The packing list is located inside the accessory box.
• Check the integrity of the components once unpacked.
• Check for proper location
• Ambient temperature no greater than 90˚F
• Do not install near heat source
• Do not install near vapor source
• Do not install near grease source
• Do not install in direct sun light
• Do not install in closed areas with insufficient air change
• Check for proper clearances
• 6” clearance on both sides of the unit
• 15” clearance on top of the unit
• 6” clearance to the back of the unit
• 35.5” at the front of the unit for door opening
• Check for unobstructed air flow at the condensing unit
Condensing Unit Installation
The condensing unit must be installed and connected in accordance with the installation manual provided with the
condensing unit. The condensing unit and the cabinet must be connected to separate electrical power supply. When
the condensing unit is provided by a third party, verify that rating meets the requirements listed above.
The blast chiller refrigeration system is of pump down type. The blast chiller controller will control the refrigeration by
closing and opening the solenoid valve located inside the blast chiller cabinet. For proper operation, make sure the
low pressure controller is set to cut out at 4 PSI and cut in at 15 PSI.
Equipment Tag
The equipment tag is located on the exterior of the unit
and displays the following information that is unique to
the unit:
• Model Number
• Serial Number
• Refrigerant Charge
• Refrigerant Pressure (Low & High)
• Electrical Volts, Phase, Hertz and Amps
• Minimum Circuit Amps
• Maximum Fuse Size (Amps)
Please have this information on hand when contacting
service or parts.
