9
Automatic Drying Cycle (Mode.) (Patent No. 4,827,627) Selections:
1 .
Drying Temperature - programmable from 160º to 200ºF in one-degree increments or from 71ºC to
93ºC in one-degree increments.
2.
Dryness Level (percentage of extraction) - programmable from 90% (less dry) to 100% (more dry) in
one-percent increments.
3.
Cool Down Time - programmable from 0 to 99 minutes in one minute increments.
4.
Cool Down Temperature - programmable from 70ºF to 100ºF in one-degree increments or from 20ºC to
37ºC in one-degree increments.
5.
Factors (Program Location - “Dryer Setup”)
a.
Factor “A” Slope Program - the Phase 7 OPL microprocessor controller (computer) monitors
how long it takes to get to the selected temperature.
1) Program selections are 1 through 9 in increments of one (1).
b.
Factor “B” Heat Loss (offset) Program - this factor setting is dependent upon the model dryer
and the type of heating unit.
1) Program selections are 1 through 99 in increments of one (1)
The Manually Loaded Auto Cycle has the “A” and “B” Factors set in “DRYER SETUP”. The (A-F) and (0-
99) cycles that have been selected to be Auto, have separate Factors for each cycle. All the parameters set in
“COOL DOWN SETUP” also pertain to the Manually loaded Auto and Manual cycles.
The “A” and ‘B” Factors have been preprogrammed by the factory as outlined on
page 51
and
SHOULD NOT BE CHANGED
unless the Phase 7 OPL microprocessor controller (computer)
should fail and is being replaced. The replacement Phase 7 OPL microprocessor controller
MUST BE
PROGRAMMED
for the particular dryer model and heating unit as shown in the “A” and “B” Factor
table on
page 51
of this manual.
