7
d. Cool Down Time - programmable from 0 to 99 minutes in one-minute increments.
e. Cool Down Temperature - programmable from 70ºF to 100ºF in one-degree increments or
from 20ºC to 37ºC in one-degree increments.
f. “A” Factor - Programmable from 0 to 9
g. “B” Factor - Programmable from 0 to 99
2. Timed (Manual) Cycle (Mode)
a. The Phase 7 OPL microprocessor controller (computer) can be programmed to reverse or not
reverse (single direction rotation). This is done in “DRYER SETUP” parameter.
b. Drying Time - programmable from 0 to 99 minutes in one-minute increments.
c. Drying Temperature - programmable from 100ºF to 200ºF in one-degree increments or from
37ºC to 93ºC in one-degree increments.
d. Cool Down Time - programmable from 0 to 99 minutes in one-minute increments.
e. Cool Down Temperature - programmable from 70ºF to 100ºF in one-degree increments or
from 20ºC to 37ºC in one-degree increments.
f.
The Spin Time can be programmed from 30 seconds to 120 seconds in one-second increments.
This is done in “COOL DOWN” Menu
g. The Stop (Dwell) Time can be programmed from 7 seconds to 10 seconds in one-second
increments. This is done in “COOL DOWN” Menu
All six (A-F) preprogrammed cycles along with cycles 0 - 99 have been programmed by the factory as outlined
on
page 49
. However, even though cycles “A -F” are the most common cycles used, they
should be
reviewed
to ensure they meet the location application or needs. Should changes be found necessary, refer to the Programming
Section of this manual.
B. MANUALLY LOADED CYCLES
For occasional or one-time special loads, the operator must enter the specific program features needed. This
cycle is not stored within the Phase 7 OPL microprocessor controller (computer) and
must be
entered each and
every time.
The Manually Loaded Cycle can be set in either the Automatic Drying Cycle (Mode)
(Patent No. 4,827,627)
or the Timed (Manual) Drying Cycle (Mode). These are selected by pressing the “AUTO” or “MAN” keys on
the keypad.
