Amcrest AMDVTENL8, User Manual

Page: 41 / 199

41
Note: The name of the command will be grayed out if the function is not supported.
Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux function, light, wiper,
rotation, etc.
The speed field controls PTZ movement speed. The value ranges from 1 to 8. 8 is the fastest and 1 is the
slowest. The remote control’s numeric keypad can be used to enter in a value.
To adjust values for Zoom, Focus, and Iris, click the buttons on either side of the function to adjust them. The
following chart will provide guidance on how to use the buttons to adjust the PTZ functionality.
Name Function
Button function Shortcut
key Function
Button function Shortcut
key
Zoom Near Far

Focus Near
│ 
Far
► │
Iris Close


Open


The PTZ control panel also supports the rotation of the camera in 8 different directions. If the buttons on the
front panel of the DVR are used, then only four of the directions will be accessible (up/down/left/right).
In the middle of the eight directional arrows, there is a button to activate the 3D Intelligent Positioning
function. To use the 3D Intelligent Positioning function, your PTZ enabled device should support this
function, and a compatible USB mouse should be plugged into the DVR.
By clicking the button and activating the 3D Intelligent Positioning, the system will go to single screen
mode. Once activated, section size can be adjusted using the mouse. The zone selected supports 4x to 16x
speeds and can use PTZ automatically to move the camera field. The smaller the designated zone, the higher
the movement speed within the zone.
Additional functions within the PTZ control panel can be opened by clicking the button. See the chart
below to see which additional functions are available.