6.
Remove the linch pin between the second and
third coulter.
7.
Remove the opposite linch pin between the fifth
and sixth coulter.
The implement is set to a row spacing of 70 cm or 75
cm.
8.
Telescope the implement out.
The second and sixth coulter are pushed 10 cm
outwards.
The inner telescopic rod
2
lies beside the 50-cm
pegging position
3
.
9.
telescope the implement in.
The linch pin between the third and fourth coulter
4
is without tension.
The linch pin between the fourth and fifth coulter
is without tension.
CMS-I-00003843
10. Remove the linch pin
1
between the third and
fourth coulter.
11. Move the linch pin to the desired position
between the third and fourth coulter.
12. Move the opposite linch pin to the desired
position between the fourth and fifth coulter.
CMS-I-00002809
13. Remove the linch pin
1
between the second
and third coulter.
14. Move the linch pin to the desired position
between the second and third coulter.
15. Move the opposite linch pin to the desired
position between the fifth and sixth coulter.
16. Telescope the implement out.
The desired row spacing is adjusted between all
of the coulters.
CMS-I-00002808
6 | Preparing the machine
Preparing the implement for operation
MG6149-EN-GB | J.1 | 18.10.2022 | © AMAZONE
149
Summary of Contents for Precea 4500-2
Page 255: ......
