Alvarion BreezeACCESS Wi2, System Manual

Page: 37 / 252

Hardware Description
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 15
2.1.3.2 Controlled Mode
The status lights provide the following information when an AP is operating in controlled mode:
Once the AP has established a secure tunnel with a CTRL, the status lights revert to their normal
operation:
„
Power light is solid to indicate that the AP is fully operational
„
Ethernet light blinks to indicate the presence of traffic on the Ethernet port
„
Wireless light blinks to indicate the presence of traffic on the wireless port
Status Light
State Description
Power Act Off There is no power to the WI2SR-1.
Flashing The WI2-SR-1 is starting up.
Solid The WI2-SR-1 is fully operational.
Link on Ethernet Off Port is not connected or there is no activity.
Flashing Ethernet port is transmitting or receiving.
Solid The light comes on for a short period when the link is established.
Link on Wireless Flashing Wireless port is receiving data.
Power Solid When the WI2-SR-1is plugged in.
Status Light Behavior Description
Power Act blinks slowly. WI2-SR-1 is looking for an IP address
Power Act, Link on Ethernet, and Link on Wireless
light each turn ON and OFF one after the other,
giving the impression of movement from left to right WI2-SR-1 has obtained an IP address and is
attempting to discover a WI2-SR-CTRL.
Power Act light is solid.
Link on Ethernet blinks until the tunnel is established.
WI2-SR-1 has found a WI2-SR-CTRL and is
attempting to establish a secure tunnel with it.
Power Act light and Link on Ethernet light blink
alternatively and quickly.
Wireless light is off.
WI2-SR-1 has received a discovery reply from two or
more WI2-SR-CTRLs with the same priority setting.
The WI2-SR-1 is unable to connect with either until
the priority conflict is resolved.