Alvarion BreezeACCESS Wi2, System Manual

Page: 46 / 252

24 BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Chapter 2 - Hardware Installation
2.3.3.2 Adapting the Ethernet Cable for Connecting to
BreezeACCESS SU-ODU
The 55 cm Ethernet cable supplied with the unit has crossed Ethernet connections which have to be
adapted for connecting the unit to a BreezeACCESS ODU:
1 Cut the cable as close as possible to the connector that should be connected to the ODU (the end
without the service box).
2
Use a crimp tool for RJ-45 connectors to prepare the wires. Insert them into the appropriate pins
of the spare RJ-45 connector supplied with the unit and use the tool to crimp the connector.
Make sure to do the following:
º
Remove as small a length as possible of the external jacket. Verify that the external jacket is
well inside the sealing cover when connected to the unit, to ensure good sealing.
º
Pull back the shield drain wire before inserting the cable into the RJ-45 connector, to ensure
a good connection with the connector's shield after crimping.
The cable should provide straight pin-to-pin connections on both ends. Figure 2-10 shows the
required wire pair connections:
The color codes used in the standard cable supplied by with the unit are listed in the table below.
Figure 2-10: Ethernet Connector Pin Assignments
Wire color Pin
Blue 1