6
Before proceeding
make certain that you
understand
the IMPORTANT
INFORMATION
section of this manual
If any burner fails to
ignite, turn the control
knob off (clockwise)
and also turn the
cylinder valve off. Wait
five minutes before
attempting to relight
following the correct
ignition sequence from
left to right.
Do not touch any hot
BBQ parts.
The outside of the
BBQ bottom especially
becomes very hot
during use. Use
protective gloves to
handle any parts that
might become hot
during use.
LIGHTING YOUR GAS BBQ
The lid must be open when lighting the burners.
Depress any/or required knobs and turn anti-clockwise. You will
hear an audible "click", which will ignite the powerful pilot flame.
Keep the knob depressed until the burner is alight.
Release and turn the control knob anti-clockwise for the desired
setting. Follow the same procedure as above to ignite the other
burners. If for some reason the burner(s) does not ignite, refer to
the Manual Ignition instructions that follow.
After use, first turn off the gas control valve at the cylinder and
then turn ALL control knobs to the OFF position. The lid must be
open when lighting the burners.
MANUAL IGNITION
1. Open the gas control valve at the cylinder
2. Remove grids. The burners will be visible. FIRST strike a
match and hold approximately 40 mm away from the RIGHT
HAND burner, then push and turn the rightmost control knob
anti-clockwise to the HIGH position.
3. If the burner fails to ignite after 5 seconds, turn to the OFF
position and wait 2 minutes. Then begin again from Step 2.
If the burner still fails to light after several attempts, call your
local dealer for service.
4. After use, first turn off the gas control valve at the cylinder
and then turn ALL control knobs to the OFF position.
LEFT SIDE BURNER IGNITION
1. Open the left side burner lid.
2. Turn the control knobs clockwise to “OFF” position.
3. Connect the regulator to the gas bottle. Turn the gas supply
“ON” at the cylinder. Use soapy water to check gas leakage
between the bottle and the regulator.
4. Push down and turn the left hand burner control knob anti-
clockwise to the 90° position (Full rate position). An audible
click will be heard, this should light the burner. Check that
the burner is alight. If the burner has not lit, repeat this
process.
5. If the burner has not lit after two attempts, turn ‘OFF’ the gas
cylinder valve and wait 5 minutes before retrying the ignition
sequence.
Summary of Contents for SPHINX
Page 2: ......