
Bullnose seal
Use gas pipe C and A & B to connect the main burners and side
burner. Line up the holes in the side table assembly with the
holes of burner assembly. Place 5 screws (M6x12) in holes of the
side table and fully tighten. Connect the side burner’s hose
assembly to the main valve assembly.
Once you have installed the BBQ, you must check for gas leaks
before using the BBQ (for detailed steps on testing, please refer
to “leak testing” below).
Once you have connected all the parts according to the above
instructions, please check if there are any parts that have not
been used. If so please repeat the above instructions – there are
no spare parts supplied.
Before using, please remove the foam and plastic packing
material. Please also clean your BBQ.
FIXING THE REGULATOR TO THE CYLINDER
Ensure that all the BBQ control knobs are in the OFF position.
Connect the regulator to the gas cylinder according to your
regulator and cylinder dealer’s instructions.
Always check that the bullnose seal on the regulator is in place
and in good condition before connecting the regulator to the
cylinder. Perform this check every time a cylinder is connected or
changed. Always make sure that the thread is fully engaged and
properly tightened.
Please note that the thread on the regulator is a LEFT HAND
thread and must be turned in an ANTI-CLOCKWISE direction to
tighten it when facing the cylinder valve.
5
Summary of Contents for SPHINX
Page 2: ......