
Always inspect the hose for cuts, cracks, or excessive wear
before use. If the hose is damaged, it must be replaced with a
hose suitable for use with LPG and which meets the national
standards for the country of use (South Africa: SANS 1156-2 or
BS3212). The length of the hose shall not exceed 1,5m.
CONNECTING THE GAS HOSE TO THE BBQ
Connect the gas hose to the gas manifold inlet on the BBQ.
Do not overtighten. Do not use any sealing tape or liquid on the
connection.
FIXING THE REGULATOR TO THE CYLINDER
Ensure that all the BBQ control knobs are in the OFF position.
Connect the regulator to the gas cylinder according to your
regulator and cylinder dealer’s instructions.
Always check that the bullnose seal on the regulator is in place
and in good condition before connecting the regulator to the
cylinder. Perform this check every time a cylinder is connected or
changed. Always make sure that the thread is fully engaged and
properly tightened.
Please note that the thread on the regulator is a LEFT HAND
thread and must be turned in an ANTI-CLOCKWISE direction to
tighten it when facing the cylinder valve.
ASSEMBLY OF SIDE TABLES
The hood, body, storage cabinet, main burners, back burner, side
burners are all pre-assembled and do not need to be adjusted.
The left and right side panels are separated from the body for
shipping.
The gas control panel for the side burners and main burners are
separate, and require assembly. Please use washers and bolts to
connect the left and right panels to the body of the barbecue
(see the picture on the following page).
4
Summary of Contents for SPHINX
Page 2: ......