14
-EN
01GB05_1INA-W900E.fm
ALPINE INA-W900E 68-16909Z25-A (EN)
Adjusting the Monitor Viewing Angle
Adjust the monitor’s angle for better visibility.
1
Touch
[SETUP]
for the selected source on the main
screen.
The setup selection screen is displayed.
2
Touch
[DISPLAY SETUP]
.
3
Touch
[
]
or
[
]
of TILT to adjust the desired
monitor angle.
Pressing the buttons changes the screen angle by 5 stages.
4
Touch
[
]
to return to the previous screen.
Touch
[ESC]
to return to the main source screen that was
displayed before the setup operation was started.
•
This function is adjustable while driving.
•
If the monitor touches an obstacle while the angle is being adjusted,
it will stop immediately.
•
The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
•
If the voltage of the vehicle’s battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.
Adjusting the Volume
Adjust the volume by pressing
or
.
Volume decreases/increases continuously by pressing and
holding
or .
Volume: 0 - 35
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press
MUTE
to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing
MUTE
again will bring the audio back to its
previous level.
How to view the Display
•
Be sure to touch the button lightly with the pad of your finger on the
display to protect the display.
•
If you touch a button and there is no reaction, remove your finger
from the display, and try again.
Here is an example explanation for the Radio mode display on how to
recall a source.
1
Press
SOURCE/
on the unit.
The SOURCE selection screen is displayed.
Display example for SOURCE selection screen
Changes to SETUP selection screen.
Changes to main source screen.
Displays source modes that can be selected
(The kind of source modes that are displayed varies
depending on connection and setting.)
Returns to the previous screen.
Changes to the REAR selection screen when “Setting
the Picture Output” (page 66) is set to ON.
The information about the current source.
e.g. The DISC image, Track NO. and Track time will be
displayed in DISC mode.
Soft button operation
About the button descriptions used in this Owner’s Manual
•
Soft buttons, ones found in the display, are shown in bold
enclosed in brackets, [ ] (e.g.
[ESC]
).
•
When a soft button and a head unit button have the same
function, the explanations in this Owner’s Manual will describe
the function of the soft button.
Recalling the Source
01GB00INA-W900E.book Page 14 Monday, September 13, 2010 9:52 AM
