Alliance Laundry Systems IYG065J, Original Instructions Manual

Page: 50 / 106

The Wash Sequence
Display Mes-
sage Default Information Limits
Inlet I1-I2-I3-I5-
I6-I8 The suggested inlet valves are related to the temperature and the soap
box to be used.
NOTE: If you insert other inlet valves than the suggested
ones, problems can occur at the water fill process.
I1...I8
Level Normal Low The suggested water level depends on the machine Type. Refer to Table 6
RPM - The suggested RPM depends on the machine Type. Refer to Table 7
Detergents
Menu…
Supply 1, …, 8
0 seconds Time selection for Soap Boxes (hopper) and external liquid soap sup-
plies.
You can program up to 4 supplies at the same time. If you have pro-
grammed more then 4 supplies an error message will be generated.
Put the time of the supplies back to zero until not more than 4 non-
zero time values are remaining.
(Liquid Soap Supplies Must Be Switched On At The Configuration
Menu)
0 - 99 seconds
On Time 12 seconds The wash action (motor "On" Time). Gentle wash action : 3 seconds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Off Time 3 seconds The wash action (motor "Off" Time). Gentle wash action : 12 sec-
onds.
(The suggested default values can be adjusted at the Initialization
menu)
1 - 99 seconds
Time 7.0 minutes The Wash Sequence Time.
(for 0 Minutes the Wash sequence will be skipped) (programmable in
steps of 0.5 Minutes)
0 - 99.5 minutes
Pause No When a signal Pause is programmed, a pause will be introduced at the
end of the Wash Step. This allows the operator to add soap for the next
step. A buzzer signal warns the operator that the cycle has been inter-
rupted. No / Yes
Table 19
The Cooldown Sequence
• Prewash
• Wash
•
Cooldown
• Rinse
• Final Rinse
• Soak
• Spray
• No wash
• After a Hot wash you can program a Cooldown Sequence to
avoid temperature shock and shrinking of the garments.
• The drain step after the Hot wash must be put on NO DRAIN.
• No inlets are programmable :
• machine with three water inlets: inlet 7 is the standard in-
let.
• machine with two water inlets: inlet 1 is the standard inlet.
• The water level can‘t be programmed as the process of adding
and draining water doesn’t allow this.
Programming
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
50 Part No. D1631ENR7