Replacing the Drive-Bay
Heat-Sensor
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before Working Inside Your Computer
.
After working inside your computer, follow the instructions
in
After Working Inside Your Computer
. For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1
Reroute the drive-bay heat-sensor in the sensor bracket.
2
Align the drive-bay heat-sensor in the securing clip.
3
Close and press the release tab on the securing clip.
4
Lay the chassis on the left side.
5
Connect the drive-bay heat-sensor cable to the connector on the system
board. See “
System Board Components
”.
Post-requisites
1
Replace both the left and right side-panels. See “
Replacing the Side
Panels
”.
2
Replace the
stability foot
.
61
Summary of Contents for Area-51 R2
