Removing the Drive-Bay
Heat-Sensor
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before Working Inside Your Computer
.
After working inside your computer, follow the instructions
in
After Working Inside Your Computer
. For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Prerequisites
1
Remove the
stability foot
.
2
Remove both the left and right side-panels. See “
Removing the Side
Panels
”.
Procedure
1
Lay the chassis on the left side.
2
Locate the drive-bay heat-sensor connector (SENSOR1) on the system
board. For more information on the drive-bay heat-sensor connector, see
“
System-Board Components
”.
58
Summary of Contents for Area-51 R2
