Replacing the Logo Board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
Before Working Inside Your Computer
.
After working inside your computer, follow the instructions
in
After Working Inside Your Computer
. For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the logo board to the screw holes on the bracket
and slide the logo board in.
2
Replace the screws that secure the logo board to the bracket.
3
Slide the logo board inside the chassis.
4
Replace the screw that secure the logo board to the bracket.
5
Route and connect the cables that you removed from the connectors on
the logo board.
Post-requisites
1
Replace both the left and right side-panels. See “
Replacing the Side
Panels
”.
2
Replace the
stability foot
.
116
Summary of Contents for Area-51 R2
