Algema BLITZLADER 2, Operating Instructions Manual

Page: 43 / 108

4 Operation and running Eder GmbH
42 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
•
•
•
•
4.4 Radio remote control*
After switching on the setup functions on the touch panel ( see "Tilt plateau operation",
page 21 ), wait approx. 3-4 seconds (system self-diagnosis). Then press the Start key
(1). Alternatively, the radio remote control can also be activated by pressing the Radio
remote control button on the touch panel.
The radio remote control is active when the radio remote control button on the touch
panel lights up and the LED function indicators of the radio remote control flash (see
separate operating instructions for radio remote control).
• After the last command received, the radio remote control remains active for approx.
five minutes. It then switches off again. This is done by automatically activating
the emergency stop function.
Press the desired keys (2-4, 6-8) on the radio remote control to activate the
corresponding output on the receiver. The functions are analogous to the manual
control panel ( see "Tilt plateau operation", page 21 ). The buttons must remain pressed
during the work process.
To deactivate the radio remote control, press the Stop button (4). The button is
designed as an
emergency stop function.
In this state, all functions are switched
off. To reactivate the setup functions, see the "Emergency stop function" section.
Radio remote
control:
1. Start
2. Rope winch roll up
3. Plateau from
4. Ramps on
5. Stop (emergency
stop)
6. Cable winch
unwind
7. Plateau on
8. Ramps from
Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 43 / 108
The buttons of the radio remote control are actuated
unintentionally!
Unintentional operation may result in damage to property or
personal injury.
°
Always keep an eye on the radio remote control when it is
activated.
° Do not keep the radio remote control in your trouser or jacket
pocket.
°
Do not place any objects on the radio remote control.
Deactivate the radio remote control by switching to manual control on
the touch panel if the radio remote control is not required.
The danger zone cannot be seen when operating the radio remote
control!
Property damage and personal injury may occur.
°
Only operate the radio remote control when you can see the
danger zone around the plateau and the drive-up ramps.
If an LED radio indicator on the upper edge of the radio remote control
lights up or flashes
red when one of the keys is pressed, the batteries of
the radio remote control must be replaced. Changing the batteries is not
part of these operating instructions.
Also observe the enclosed separate operating instructions for the radio
remote control.
Other versions of the radio remote control 8-
channel radio remote control*:
An 8-channel radio control system is optionally available instead of the 6-channel radio
control system shown (not illustrated). Channels 1 to 6, the Start and Stop buttons and the
emergency stop function have the same functions as the 6-channel radio remote control
described. In addition, the rotating beacons* and worklights* can be switched on and off
using the buttons on channels 7
and 8 ( see "Rotating beacon*, worklights* and ambient
lighting front* and rear*", page 46 ).