Algema BLITZLADER 2, Operating Instructions Manual

Page: 25 / 108

4 Operation and running Eder GmbH
24 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
The wheel stop is not fastened properly!
The wheel stop can come loose while driving.
°
Make sure that the pins of the wheel stop are fixed in the holes
of the railing.
The turnbuckle must be able to be closed above the dead center
with a decently strong hand pressure, but without force. If
necessary, change the setting of the turnbuckle by screwing the
eyelet in or out further.
°
•
Load the vehicle to be transported ( see "Loading without winch*", page 25 or
"Loading with winch*", page 26 ). We recommend driving the vehicle forwards
onto the car transporter.
•
The loaded vehicle must be centered on the plateau in relation to the center
longitudinal axis of the car transporter and the parking brake must be applied. The
lowest gear must be engaged or, in the case of an automatic transmission, the
selector lever must be in the P position. The wheels of the front axle must be in
contact with the front wheel stop.
•
Fasten the second wheel stop in the same way as the front wheel stop immediately
behind the rear axle. The turnbuckle must point to the rear.
• A trapezoidal wheel securing strap must be attached at an angle of approx. 45° to all
wheels of the loaded vehicle above the center of the wheel and pretensioned by
means of a ratchet (see illustrations below).
Please also refer to the separate instructions for the harness wheel
securing straps.
•
After a distance of approx. 50 km, the pretension of the trapezoidal wheel lock
belts must be checked and retightened if necessary.
Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 25 / 108
4.1.5 Loading without rope winch*.
Get out of the loaded vehicle!
Fall from the plateau.
°
°
° When getting out of the loaded vehicle, hold on to the handles
provided for this purpose in the area of the driver's door, on the
door frame or on the roof.
Leave the plateau in the tilted-up state to the rear.
If necessary, close the driver's door of the loaded vehicle
after tipping it off the ground.
Unintended rolling back or acceleration of the vehicle to be loaded!
People can be hit or run over.
°
No persons are allowed on the platform, the ramps or behind the
car transporter during loading.
The loaded vehicle is positioned incorrectly!
Axle loads of the car transporter are exceeded.
The car transporter can no longer be steered safely enough due to
an underloaded front axle.
° The
loaded vehicle must be positioned in such a way that the
permissible axle loads of the car transporter are not exceeded.
°
To ensure steerability, the front axle load of the car transporter
must be more than approx. 30% of the actual weight of the
loaded car transporter.
•
•
Secure the loading point ( see "Loading and unloading point", page 20 ).
• Extend the drive-up ramps and tilt the plateau ( see "Operating the tilt plateau", page
21 ).
• Check the position of the front wheel stop and change it if necessary ( see "Securing
the loaded vehicle", page 23 ).
Slowly drive the vehicle onto the plateau in the center of the car transporter's central
longitudinal axis until the front wheels are in contact with the wheel stop.