Algema BLITZLADER 2, Operating Instructions Manual

Page: 27 / 108

4 Operation and running Eder GmbH
26 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition
04/2021
Non-adapted steering movements during loading!
The vehicle to be loaded may fall from the drive-up ramps or from the
plateau.
°
Drive the vehicle straight onto the car transporter, if necessary call
in a guide.
•
• On the loaded vehicle, apply the parking brake and engage the lowest gear or, in the
case of automatic transmission, move the selector lever to the P position.
• Tilt the plateau and retract the drive-up ramps ( see "Tilt plateau operation", page
21 ).
Secure the loaded vehicle ( see "Securing the loaded vehicle", page 23 ).
4.1.6 Loading with cable winch*.
Get out of the loaded vehicle!
Fall from the plateau.
°
°
°
When getting out of the loaded vehicle, hold on to the handles
provided for this purpose in the area of the driver's door, on the
door frame or on the roof.
Leave the plateau in the tilted-up state to the rear.
If necessary, close the driver's door of the loaded vehicle
after tipping it off the ground.
Unintentional rolling back or acceleration of the vehicle to be
loaded!
People can be hit or run over.
°
No persons are allowed on the platform, the ramps or behind the
car transporter during loading.
Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 27 / 108
The loaded vehicle is positioned incorrectly!
Axle loads of the car transporter are exceeded.
The car transporter can no longer be steered safely enough due to
an underloaded front axle.
°
The loaded vehicle must be positioned so that the permissible
axle loads of the car transporter are not exceeded.
To ensure steerability, the front axle load of the car
transporter must be more than approx. 30% of the actual
weight of the loaded car transporter.
°
The rope is damaged!
Injuries caused by the rope.
The rope may break.
°
Wear work gloves.
°
Damaged ropes must not be used ( see "Checking steel ropes ",
page 72 ).
Also observe the separate operating instructions for the cable winch and
the safety notes under
"Safety notes for loading and unloading", page 16 .
The installation situation of the cable winch may differ from the original
installation instructions of the cable winch. For a straight pull and for rope
shearing, the rope is always wound up from above, observing the
prescribed direction of rotation of the rope winch.
Winch operation:
Cable winch:
1. Freewheel
2. Detent bar
3. Handle
4. Storage eyelet
5. Plug cable remote control