Algema BLITZLADER 2, Operating Instructions Manual, Page: 32 / 108

4 Operation and running Eder GmbH
32 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
4.1.8 Unloading with rope winch*.
Get in the loaded vehicle!
Fall from the plateau.
°
°
° If necessary, open the driver's door of the loaded vehicle from
the ground before tipping.
Enter the plateau in the upturned state and from behind.
When entering the loaded vehicle, hold on to the designated
handholds in the area of the driver's door, on the door frame or
on the roof.
Unintentional rolling back or acceleration of the vehicle to be
unloaded!
People can be hit or run over.
° During unloading, no persons are allowed on the plateau, the
drive-up ramps or behind the car transporter.
The rope is damaged!
Injuries caused by the rope.
The rope may break.
°
Wear work gloves.
° Damaged ropes must not be used ( see "Checking steel ropes ",
page 72 ).
Also observe the separate operating instructions for the cable winch and
the safety notes under
" Safety notes for loading and unloading", page 16 .
Winch operation:
See "Loading with cable winch*", page 26 .
Unload:
• Secure the unloading point ( see "Loading and unloading point", page 20 ).
• Before unloading, check again that the parking brake is applied on the loaded vehicle
and that the lowest gear is engaged or, in the case of an automatic transmission, that
the selector lever is in the P position.
•
Check the position of the winch and move it if necessary ( see "Loading with the
cable winch*", page 26 ).