Algema BLITZLADER 2, Operating Instructions Manual

Page: 22 / 108

4 Operation and running Eder GmbH
22 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
•
•
control system ( see "Radio remote control*", page 42 ).
The illumination of the keys (6-11) on the manual control panel goes out when the
radio remote control is active.
If you want to switch back to manual control, press the Manual control key (4). The
following description in this section refers to operation with the manual control.
Operation with the radio remote control makes sense.
• All keys (6-11) on the manual control panel must remain pressed while the function is
being activated. If the key is released, the function stops. Always release the keys
when the selected function has reached its end position and no further movement
can be detected.
•
Extend the drive-up ramps completely using the Ramps off button (8) until the end
position is reached and the movement stops. The drive-up ramps hang down by
approx. 10° in the end position. The flexible suspension of the drive-up ramps allows
you to compensate for uneven floors.
• Next, the plateau can be tilted up by pressing the Plateau button (10). The tipping
process stops automatically as soon as the tipping sensors at the lower rear end of
the plateau touch the ground. Alternatively, the sensor end position tilt scissors stops
the tipping when the vehicle is on uneven ground and the tilt scissors are at the stop
before the tilt sensors reach the ground.
• The vehicle can then be loaded or unloaded and secured, (see
4.1.4 "Securing the loaded vehicle" to 4.1.9 "Trailer transport with loading ball* on the
loading area" ). For loading or unloading with the rope winch*, the rope can be unrolled
with the Unroll rope winch button (6) and rolled up with the Roll up rope winch button
(7).
• The plateau is tilted down with the Plateau down key (11). Make sure that at the end of
the tilting process the tilting shear moves over the dead center and pulls the plateau
down safely. This process is associated with an audible click, which should be
perceived by the operator.
You can then retract the ramps completely using the Ramps on (9) button.
• As soon as the plateau and the ramps are in the drive position again, the body
functions can be deactivated with the main switch (1). Alternatively, the body
functions deactivate themselves when the parking brake is released (immediately) or
the ignition is switched off (approx. 60 sec. follow-up time).
Driving with the plateau not fully tilted or with the ramps not fully
retracted!
Damage may occur to the plateau, the tipping shear, the slide-in
modules or the drive-up ramps.
Flowing traffic could be endangered.
°
The plateau must always be fully tilted and the drive-up ramps
fully retracted before starting to drive.